7 Steps to Replace Your Fridge Micro Switch

7 Steps to Replace Your Fridge Micro Switch

You can extend the life of your appliances by learning how to do basic repairs. This can help you save a lot of money. This article will help you replace the microswitch on your refrigerator. It may seem difficult at first to replace the unit. It will be much easier to replace the team if you follow these steps.

1. Get the tools you need

Duct tape
Putty knife
Flat-blade screwdriver
Micro-switch

2: Disconnect from the Power

Before you start working on any electrical appliance, disconnect the power supply. This is crucial for your safety as well as the safety of those around you. Make sure that you have turned off the power supply.

3. Take off the drip tray

Next, remove the drip tray. This is at the bottom. To protect the finish, you can use duct tape. You can then place the putty knife under the escutcheon and then pull it out to separate it.

It will be connected to several spots. You should begin at the bottom and then lift it up by tilting it.

The 5-pin plug will be found after the drip tray is removed. This component is the power source for the switches. You just need to disconnect the plug from the wall and place it in a safe place before moving on to the next step.

4. Disconnect the Micro-Switch

You can now access the microswitch. These will be secured with plastic tabs or hooks. You will need to first remove the theme from the angle and then set it aside. You can pull the switch once you have removed it. To remove the wire connector, you can use a flat-blade screwdriver. This is the microswitch you will need to replace.

See also  Unionwell Germany Is a China Micro Switches Manufacturer That Is Rising to the Occasion

5. Install the New Switch

You will now need to reverse the steps. The new switch can be taken out and connected to the wire connector. You should fix it properly. You can now rotate it in the desired position and line up the holes diagonally with the plastic posts. You may then want to push it.

To fix the locking caps, you must first turn your computer on. Finally, make sure to remove all wires.

6: Reconnect the Switches

After you have replaced your micro switch, you are able to reconnect the connector. You must ensure that the locking tab remains in place. Next, lift it up so that it rests over the dispenser housing. To lock it in place, you can tap it.

7: Finish up

After you have connected the power and installed the switch, the last step is to change the drip tray.

These are just a few steps you can take to replace your fridge’s microswitch.

Leave a Comment